|
[Sponsors] |
October 16, 2021, 17:04 |
Mirroring streamtraces
|
#1 |
Member
Adithya
Join Date: May 2021
Posts: 73
Rep Power: 4 |
Hello
I have been simulating a half model of an airplane and have been running into some strange problems while post-processing. This is true for both surface wall-shear lines and volume lines. I need to mirror my model and create streamtraces. If I first create the mirrored zone and then create streamtraces, the streamtraces in the mirrored part are not mirrored! They still folllow the original solution domain. The workaround I found was creating all my streamtraces on the original half-domain, then mirroring the domain and then recreating the new required streamtraces. This is not feasible. Has anybody faced the same issue? Any solutions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mirroring flow around cylinder tutorial | Davide95 | OpenFOAM Meshing & Mesh Conversion | 3 | March 31, 2022 07:43 |
How to rename boundary/patch after mirroring mesh in openFOAM | svramana | Main CFD Forum | 4 | September 24, 2018 11:28 |
[ICEM] Refinement and Mirroring | Starcatcher | ANSYS Meshing & Geometry | 3 | September 6, 2017 11:37 |
Are Tecplot's streamtraces different than streamlines? | Roule | Tecplot | 0 | June 23, 2016 07:54 |
[OpenFOAM] XYZ starting points of streamtraces in Paraview | deniggo | ParaView | 3 | May 22, 2013 03:02 |