Visualization the results in Tecplot 360 EX 2021 R2

ulugbey · December 22, 2021, 18:20

Hi,

I am using Tecplot 360 EX 2021 R2. I want to use Tecplot for the visualization of the solutions in Numeca.

Numeca user guide says that

The "project_computation.g" file contains the grid data.
The "project_computation.q" file contains the conservative variables.
l The "project_computation.f" file contains additional variables.

When I first open the "project_computation.g", I can visualize the geometry and the mesh. Then when I open the"project_computation.q".

I get the following error > Not allowed to load solution in existing dataset that does not have the number of variables (3) equal to the number of variables retrieved from in the solution files (8).
Try loading with a grid file.

How can I solve this problem?

Best regards

wsfowler · January 4, 2022, 14:47

The Tecplot 360 Plot3D reader requires that the grid and solution files be loaded at the same time. Try specifying both (or all three) files simultaneously when loading them.

December 22, 2021, 18:20	Visualization the results in Tecplot 360 EX 2021 R2	#1
ulugbey Member Join Date: Dec 2020 Posts: 38 Rep Power: 4	Hi, I am using Tecplot 360 EX 2021 R2. I want to use Tecplot for the visualization of the solutions in Numeca. Numeca user guide says that The "project_computation.g" file contains the grid data. The "project_computation.q" file contains the conservative variables. l The "project_computation.f" file contains additional variables. When I first open the "project_computation.g", I can visualize the geometry and the mesh. Then when I open the"project_computation.q". I get the following error > Not allowed to load solution in existing dataset that does not have the number of variables (3) equal to the number of variables retrieved from in the solution files (8). Try loading with a grid file. How can I solve this problem? Best regards

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Unable to load .ccm file in tecplot 360 ex	sidharath	Tecplot	4	April 11, 2017 04:57
CFX-Post and Tecplot 360	Rogerio Fernandes Brito	CFX	2	September 28, 2008 14:45
Exporting to Tecplot 360	Rogerio Fernandes Brito	CFX	1	March 24, 2008 15:51
export transient CFX results to tecplot	n.r.	CFX	0	October 26, 2007 06:46
export CFX results to Tecplot	Cui	CFX	6	January 27, 2004 02:55

January 4, 2022, 14:47		#2
wsfowler Senior Member Scott Fowler Join Date: May 2009 Posts: 106 Rep Power: 16	The Tecplot 360 Plot3D reader requires that the grid and solution files be loaded at the same time. Try specifying both (or all three) files simultaneously when loading them.