Introduction to turbulence/Turbulence kinetic energy
|Nature of turbulence|
|Reynolds averaged equation|
|Turbulence kinetic energy|
|Stationarity and homogeneity|
|Free turbulent shear flows|
|Wall bounded turbulent flows|
| Study questions
... template not finished yet!
Fluctuating kinetic energy
It is clear from the previous chapter that the straightforward application of ideas that worked well for viscous stresses do not work too well for turbulence Reynolds stresses. Moreover, even the attempt to directly derive equations for the Reynolds stresses using the Navier-Stokes equations as a starting point has left us with far more equations than unknowns. Unfortunately this means that the turbulence problem for engineers is not going to have a simple solution: we simply cannot produce a set of reasonably universal equations. Obviously we are going to have to study the turbulence fluctuations in more detail and learn how they get their energy (usually from the mean flow somehow), and what they ultimately do with it. Our hope is that by understanding more about turbulence itself, we will gain insight into how we might make closure approximations that will work, at least sometimes. Hopefully, we will also gain an understanding of when and why they will not work.
An equation for the fluctuating kinetic energy for constant density flow can be obtained directly from the Reynolds stress equation derived earlier (see equation 35 in the chapter on Reynolds averaged equations) by contracting the free indices. The result is:
where the incompressibility condition ( ) has been used to eliminate the pressure-strain rate term, and .
The last term can be simplified by recalling that the velocity deformation rate tensor, , can be decomposed into symmetric and anti-symmetric parts; i.e.,
where the symmetric part is the strain-rate tensor, , and the anti-symmetric part is the rotation-rate tensor , defined by:
Since the double contraction of a symmetric tensor with an anti-symmetric tensor is identically zero, it follows immediately that:
Now it is customary to define a new variable k, the average fluctuating kinetic energy per unit mass, by:
By dividing equation 1 by equation 2 and inserting this definition, the equation for the average kinetic energy per unit mass of the fluctuating motion can be re-written as:
The role of each of these terms will be examined in detail later. First note that an alternative form of this equation can be derived by leaving the viscous stress in terms of the strain rate. We can obtain the appropriate form of the equation for the fluctuating momentum from equation 21 in the chapter onorigins of turbulence by substituting the incompressible Newtonian constitutive equation into it to obtain:
If we take the scalar product of this with the fluctuating velocity itself and average, it follows (after some rearrangement) that:
Both equations 6 and 8 play an important role in the study of turbulence. The first form given by equation 6 will provide the framework for understanding the dynamics of turbulent motion. The second form, equation 8 forms the basis for most of the second-order closure attempts at turbulence modelling; e.g., the socalled k-e models ( usually referred to as the “k-epsilon models”). This because it has fewer unknowns to be modelled, although this comes at the expense of some extra assumptions about the last term. It is only the last term in equation 6 that can be identified as the true rate of dissipation of turbulence kinetic energy, unlike the last term in equation 8 which is only the dissipation when the flow is homogeneous. We will talk about homogeniety below, but suffice it to say now that it never occurs in nature. Nonetheless, many flows can be assumed to be homogeneous at the scales of turbulence which are important to this term, so-called local homogeniety.
Each term in the equation for the kinetic energy of the turbulence has a distinct role to play in the overall kinetic energy balance. Briefly these are:
- Rate of change of kinetic energy per unit mass due to non-stationarity; i.e., time dependence of the mean:
- Rate of change of kinetic energy per unit mass due to convection (or advection) by the mean flow through an inhomogenous field :
- Transport of kinetic energy in an inhomogeneous field due respectively to the pressure fluctuations, the turbulence itself, and the viscous stresses:
- Rate of production of turbulence kinetic energy from the mean flow(gradient):
- Rate of dissipation of turbulence kinetic energy per unit mass due to viscous stresses:
These terms will be discussed in detail in the succeeding sections, and the role of each examined carefully.
Rate of dissipation of the turbulence kinetic energy
The last term in the equation for the kinetic energy of the turbulence has been identified as the rate of dissipation of the turbulence energy per unit mass; i.e.,
It is easy to see that always, since it is a sum of the average of squared quantities only (i.e. ). Also, since it occurs on the right hand side of the kinetic energy equation for the fluctuating motions preceded by a minus sign, it is clear that it can act only to reduce the kinetic energy of the flow. Therefore it causes a negative rate of change of kinetic energy; hence the name dissipation.
Physically, enegry is dissipated because of the work done by the fluctuating viscous stresses in resisting deformation of the fluid material by the fluctuating strain rates; i.e.
This reduces to equation 14 only for a Newtonian fluid. In non-Newtonian fluids, protions of this product may not be negative implying that it may not all represent an irrecoverable loss of fluctuating kinetic energy.
It will be shown in the following chapter on stationarity and homogenity that the dissipation of turbulence energy mostly takes place at the smallest turbulence scales, and that those scales can be characterized by so-called Kolmogorov microscale defined by:
In atmospheric motions where the length scale for those eddies having the most turbulence energy (and responsible for the Reynolds stress) can be measured in kilometers, typical values of the Kolmogorov microscale range from 0.1 - 10 millimeters. In laboratory flows where the overall scale of the flow is greatly reduced, much smaller values of are not uncommon. The small size of these dissipative scales greately complicates measurement of energy balances, since the largest measuring dimension must be about equal to twice the Kolmogorov microscale. And it is the range of scales, , which makes direct numerical simulation of most interesting flows impossible, since the required number of computational cells is several orders of magnitude greater that . This same limitation also affects experiments as well, which must often be quite large to be useful.
One of the consequences of this great separation of scales between those containing the bulk of the turbulence energy and those dissipating it is that the dissipation rate is primarily determined by the large scales and not the small. This is because the viscous scales (which operate on a time scale of ) dissipate rapidly any energy sent down to them by non-linear processes of scale to scale energy transfer. Thus the overall rate of dissipation is controlled by the rate of energy transfer from the energetic scales, primarily by the non-linear scale-to-scale transfer. This will be discussed later when we consider the energy spactrum. But for now it is important only note that a consequence of this is that the dissipation rate is given approximately as:
where and is an integral length scale. It is easy to remember this relation if you note that the time scale of the energetic turbulent eddies can be estimated as . Thus can estimated as .
Sometimes it is convenient to just define the "length scale of the energy containing eddies" (or the pseudo-integral scale) as:
Almost always , but the relation is at most only exact theoretically in the limit of infinite Reynolds number since the constant of proportionality is Reynolds number dependent. The Reynolds number dependence of the ratio for grid turbulence is illustrated in Figure 4.1. Many interpret this data to suggest that this ratioapproaches a constant and ignore the scatter. In fact some assume ratio to be constant and even refer to though it were the real integral scale. Others argue that the scatter is because of the differing upstream conditions and that the ratio may not be constant at all. It is really hard to tell who is right in the absence of facilities or simulations in which the Reynolds number can vary very much for fixed initial conditions. This all may leave you feeling a bit confused, but that’s the way turbulence is right now. It’s a lot easier to teach if we just tell you one view, but that’s not very good preparation for the future.
Here is what we can say for sure. Only the integral scale, , is a physical length scale, meaning that it can be directly observed in the flow by spectral or correlation measurements (as shown in the following chapters on stationarity and homogenity and homogenous turbulence). The pseudo-integral scale, , on the other hand is simply a definition; and it is only at infinite turbulence Reynolds number that it may have physical significance. But it is certainly a useful approximation at large, but finite, Reynolds numbers. We will talk about these subtle but important distinctions later when we consider homogeneous flows, but it is especially important when considering similarity theories of turbulence. For now simply file away in your memory a note of caution about using equation 17 too freely. And do not be fooled by the cute description this provides. It is just that, a description, and not really an explanation of why all this happens — sort of like the weather man describing the weather. Using equation 18, the Reynolds number dependence of the ratio of the Kolmorgorov microscale, , to the pseudo-integral scale, , can be obtained as:
Figure 4.1: Ratio of physical integral length scale to pseudo-integral length scale in homogeneous turbulence as function of local Reynolds number, .
Where the turbulence Reynolds number, , is defined by:
Example: Estimate the Kolmogorov microscale for and for air and water.
- air For air, . Therefore , so or .
- water For water, . Therefore , so or .
Exercise: Find the dependence on of the time-scale ration between the Kolmorogov microtime and the time scale of the energy-containing eddies. It will also be argued later that these small dissipative scales of motion at very high Reynolds number tend to be statistically nearly isotropic; i.e., their statistical character is independent of direction. We will discuss some of the implications of isotropy and local isotropy later, but note for now that it makes possible a huge reduction in the number of unknowns, particularly those determined primarily by the dissipative scales of motion.
Thus the dissipative scales are all much smaller than those characterizing the energy of the turbulent fluctuations, and their relative size decreases with increasing Reynolds number. Note that in spite of this, the Kolmogorov scales all increase with increasing energy containing scales for fixed values of the Reynolds number. This fact is very important in designing laboratory experiments at high turbulence Reynolds number where the finite probe size limits spatial resolution. The rather imposing size of some experiments is an attempt to cope with this problem by increasing the size of the smallest scales, thus making them larger than the resolution limits of the probes being used.
Exercise: Suppose the smallest probe you can build can only resolve . Also to do an experiment which is a reasonable model of a real engineering flow (like a hydropower plant), you need (for reason that will be clear later) a scale separation of at least . If your facility has to be at least a factor of ten larger than (which you estimate as ), what is its smallest dimension?
The Kinetic Energy of the mean motion and the "Production" of Turbulence
An equation for the kinetic energy of the mean motion can be derived by a procedure exactly analogous to that applied to the fluctuating motion. The mean motion was shown in 19 in the chapter on Reynolds averaged equations to be given by:
By taking the scalar product of this equation with the mean velocity,, we can obtain an equation for the kinetic energy of the mean motion as:
Unlike the fluctuating equations, there is no need to average here, since all the terms are already averages.
In exactly the same manner that we rearrannged the terms in the eqyation for the kinetic energy of the fluctuations, we can rearrange the equation for the kinetic energy of the mean flow to obtain:
The role of all of the terms can immediately be recognized since each term has its counterpart in the equation for the average fluctuating kinetic energy.
Comparison of equations 23 and 6 reveals that the term appears in the equations for the kinetis energy of BOTH the mean and the fluctuations. There is, however, one VERY important difference. This "production" term has the opposite sign in the equationfor the mean kinetic energy than in that for the mean fluctuating kinetic energy! Therefore, whatever its effect on the kinetic energy of the mean, its effect on the kinetic energy of the fluctuations will be the opposite. Thus kinetic energy can be interchanged between the mean and fluctuating motions. In fact, the only other term involving fluctuations in the equation for the kinetic energy of the mean motion is divergence term; therefore it can only move the kinetic energy of the mean flow from one place to another. Therefore this "production" term provides the only means by which energy can be interchanged between the mean flow and fluctuations.
Understanding the manner in which this energy exchange between mean and fluctuating motions is accomplished represents one of the most challenging problems in turbulence. The overall exchange can be understood by exploiting the analogy which treats as a stress, the Reynolds stress. The term can be thought of as the working of the Reynolds stress against the mean velocity gradient of the flow, exactly as the viscous stresses resist deformation by the instantaneous velocity gradients. This energy expended against the Reynolds stress during deformation by the mean motion ends up in the fluctuating motions, however, while that expended against viscous stresses goes directly to internal energy. As we have already seen, the viscous deformation work from the fluctuating motions (or dissipation) will eventually send this fluctuating kinetic energy on to internal energy as well.
Now, just in case you are not all that clear exactly how the dissipation terms really accomplish this for the instantaneous motion, it might be useful to examine exactly how the above works. We begin by decomposing the mean deformation rate tensor into its symmetric and antisymmetric parts, exactly as we did for the instantaneous deformation rate tensor in Chapter 3; i.e.,
where the mean strain rate is defined by
and the mean rotation rate is defined by
Since is antisymmetric and is symmetric, their contraction is zero so it follows that:
Equation 28 is an analog to the mean viscous dissipation term given for incompressible flow by:
It is easy to show that this term transfers (or dissipates) the mean kinetic energy directly to internal energy, since exactly the same term appears with the opposite sing in the internal energy equations. Moreover, since always, this is a one-way process and kinetic energy is decreased while internal energy is increased. Hence it can be referred to either as "dissipation" of kinetic energy, or as "production" of internal energy. As surprising as it may seem, this direct dissipation of energy by the mean flow is usually negligible compared to the energy lost to the turbulence through the Reynolds stress term.(Remember, there is a term exactly like this in the kinetic energy equation for the fluctuating motion, but involving only fluctuating quantities; namely .) We shall show later that . What this means is that most of the energy dissipation is due to the turbulence.
There is a very important difference between equations 28 and 29. Whereas the effect of the viscous stress working against the deformation (in a Newtonian fluid) is always to remove energy from the flow (since always), the effect of the Reynolds stress working against the mean gradient can be of either sign, at least in principle. That is, it can either transfer energy from the mean motion to the fluctuating motion, or vice versa.
Almost always (and especially in situations of engineering importance), almost always so kinetic energy is removed from the mean motion and added to the fluctuations. Since the term usually acts to increase the turbulence kinetic energy, it is usually referred to as the "rate of turbulence energy production", or simply "production".
Now that we have identified how the averaged equations account for the ‘production’ of turbulence energy from the mean motion, it is tempting to think we have understood the problem. In fact, labelling phenomenon is not the same as understanding them. The manner in which the turbulence motions cause this exchange of kinetic energy between the mean and fluctuating motions varies from flow to flow, and is really very poorly understood. Saying that it is the Reynolds stress working against the mean velocity gradient is true, but like saying that money comes from a bank. If we want to examine the energy transfer mechanism in detail we must look beyond the single point statistics, so this will have to be a story for another time.
This text was based on "Lectures in Turbulence for the 21st Century" by Professor William K. George, Professor of Turbulence, Chalmers University of Technology, Gothenburg, Sweden.