 |
 |
 |
|
|
|
[Sponsors] | ||||
May 5, 2022, 14:09
|
ANSA Revolute Failed
|
#1 |
|
New Member
Andrew McFadden
Join Date: May 2022
Posts: 3
Rep Power: 4  |
Hi, I am trying to do a simple asymmetric wedge to model a confined jet flow.
I make the (1,0,0) plane and mesh the surface, then revolve the surface mesh (1 step, 5deg) to a volume mesh. The revolve fails with error "Procedure failed. Invalid element along axis occured." However, it is confusing as I had already revolved this surface mesh as a coarser mesh. When I refined it and tried to revolve the finer mesh I am getting this error. Also, it is only 2 faces that will not revolve properly. The rest of the domain revolves. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel | U.Golling | OpenFOAM Running, Solving & CFD | 52 | September 23, 2023 04:35 |
| Initial conditions for uniform flow | andreas | OpenFOAM | 5 | November 16, 2012 16:00 |
| [OpenFOAM] ParaView/Parafoam error when making animation | Disco_Caine | ParaView | 6 | September 28, 2010 10:54 |
| user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 07:31 |
| user defined function | cfduser | CFX | 0 | April 29, 2006 11:58 |
Linear Mode
