|
[Sponsors] |
May 26, 2012, 10:14 |
Inflation - Mesh Quality
|
#1 |
New Member
SaiDeepakB
Join Date: May 2012
Location: Norway
Posts: 1
Rep Power: 0 |
Hi
I am trying to simulate the flow over an airfoil (using CFX), and for that I am using inflation to resolve my boundary layer in the Ansys Workbench Meshing. I have observed that as I increase the resolution of the inflated mesh, my element quality is decreasing (0.03). So my question is whether it will have any influence on my final results, if yes, how do I increase its quality? Thanks! |
|
Tags |
airfoil, inflation layer, meshing, workbench |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 23:04 |
quality of the mesh | u k jha | ANSYS Meshing & Geometry | 1 | May 6, 2009 14:44 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |