|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Ali
Join Date: Jun 2012
Location: Canada
Posts: 15
Rep Power: 14 ![]() |
Hi Every body,
I have been using ICEM for a few months and now I need to mesh a ball valve at 50% opening but I have not been successful yet. The 100% opening was very easy (because essentially it became like a pipe with two steps in the middle as the inlet and outlet of the ball) but at 50% opening it became near impossible for me because of the rotation of the ball and the Gasket it was in. I was wondering if anyone has any idea on how to approach this in ICEM or had a similar problem? Best Regards, Ali |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 22 ![]() |
Post pictures or .tin file, it would be easier to help you !
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
payammohafezatkar
Join Date: Jun 2016
Posts: 1
Rep Power: 0 ![]() |
plz hellp me.
p.mohafezatkar@gmail.com |
|
![]() |
![]() |
![]() |
Tags |
ball valve, icem 3d |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic meshing of self-acting seat valve, how to control mesh event times? | DanielBeck | FLUENT | 1 | February 17, 2015 13:36 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |
inlet valve meshing and calculation | Julien Plenchette | Main CFD Forum | 4 | March 10, 1999 04:17 |
inlet valve meshing and calculation | PLenchette Julien | Main CFD Forum | 1 | March 5, 1999 18:37 |