|
[Sponsors] |
October 13, 2012, 04:39 |
Question about Edge Params
|
#1 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
Hi everyone,
I have one question about ICEM. I set Pre-Mesh Params -> Edge Params -> spacing 1 , spacing 2 to one value. Then I click 'okay' or 'apply' button. The values always change, like from 1 to 0.9999. But I don't like it to change even a little. May I ask how to absolutely fix that value to 1? Best regards and many thanks, lnk |
|
October 13, 2012, 12:58 |
|
#3 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
Setting it again doesn't work. I set it to 1 then press the button 'apply', it jumps to 0.999997. Then I press that button again, it changes to 0.999994. By the way, the max space is 4. So geometrically it's totally possible that the spacing 1 and 2 can be 1.
Best regards and many thanks, lnk |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM Edge Params Bunching laws | twsloss | ANSYS Meshing & Geometry | 5 | May 28, 2020 13:04 |
[TGrid] Simple Question (Simple Answers?): Edge Length adjustment for tet mesh | booz | ANSYS Meshing & Geometry | 0 | August 29, 2010 12:39 |
[ICEM] Edge Params - Spacing limit values | shogologo | ANSYS Meshing & Geometry | 4 | October 19, 2009 21:49 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
[ICEM] Edge Params | darookie | ANSYS Meshing & Geometry | 4 | August 28, 2009 12:48 |