|
[Sponsors] |
[ICEM] How to merge a surface to another in ICEM ? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 15, 2013, 07:21 |
How to merge a surface to another in ICEM ?
|
#1 |
Member
Join Date: May 2013
Posts: 45
Rep Power: 13 |
I've just imported a model into ICEM CFD and it consisted of curves only. The model can be seen below.
So I can create surfaces from the body and its fins (2 large ones and 2 small ones). But I want to merge the surfaces of the fins to the body so I will be able to mesh it correctly. The fins were not attached to the body since there weren't any point in the model. What should I do to attach the fins to the body ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Merge Hexa ICEM | ignacio | OpenFOAM Meshing & Mesh Conversion | 1 | May 8, 2013 15:43 |
surface flow lines in ICEM postprocessing | Dimitri | CFX | 0 | July 18, 2007 11:30 |
ICEM Surface from points cloud ? | Guillaume | CFX | 1 | June 13, 2007 14:42 |
ICEM CFD surface mesh | Francesco | CFX | 1 | May 31, 2006 11:09 |
How can I define a intersection surface with ICEM? | BEN EZZEDDINE Anouar | CFX | 0 | November 15, 2005 06:05 |