[ICEM] Geometry association

ErshathG · May 29, 2013, 12:16

Hi,
I am new to meshing with icem cfd. I am trying to mesh a s-shaped duct with elliptical to circle transition by creating O-Grid block. My doubt is after association of edges and curves,surface and faces.is it ok if the blocks protrude out of the actual geometry

Far · May 29, 2013, 13:48

do you get any problem in meshing? please show some pics

ErshathG · May 29, 2013, 15:20

got some problems with meshing...values of determinant in negative...but those elements are at a different location...i think the reason for that seems to be something else and am working on it...and sorry i cannot post the exact image..but i have added a image which might give some idea..the image corresponds to central plane...the red region is where the block protrudes out of the window,the yellow region is where i have the low quality elements...

1.pdf

May 29, 2013, 12:16	Geometry association	#1
ErshathG New Member Ershath Join Date: May 2013 Posts: 3 Rep Power: 12	Hi, I am new to meshing with icem cfd. I am trying to mesh a s-shaped duct with elliptical to circle transition by creating O-Grid block. My doubt is after association of edges and curves,surface and faces.is it ok if the blocks protrude out of the actual geometry

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question about Geometry vs. Meshes	EphemeralMemory	ANSYS Meshing & Geometry	2	December 8, 2016 13:02
[ANSYS Meshing] need to convert a cell based geometry into STL or CGNS	kamran_kibria	ANSYS Meshing & Geometry	0	September 15, 2011 05:14
Reg difficulties in meshing the geometry...Urgent	arunraj	ANSYS Meshing & Geometry	0	August 26, 2011 23:25
[snappyHexMesh] SnappyHexMesh meshes inside and outside of an STL geometry	villier	OpenFOAM Meshing & Mesh Conversion	17	June 15, 2010 19:51
[GAMBIT] import terrain geometry	cfdworker	ANSYS Meshing & Geometry	2	May 24, 2009 21:40

May 29, 2013, 13:48		#2
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	do you get any problem in meshing? please show some pics

May 29, 2013, 15:20		#3
ErshathG New Member Ershath Join Date: May 2013 Posts: 3 Rep Power: 12	got some problems with meshing...values of determinant in negative...but those elements are at a different location...i think the reason for that seems to be something else and am working on it...and sorry i cannot post the exact image..but i have added a image which might give some idea..the image corresponds to central plane...the red region is where the block protrudes out of the window,the yellow region is where i have the low quality elements... 1.pdf