|
[Sponsors] |
August 21, 2013, 10:23 |
Edges - Change Fractions
|
#1 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
Hi guys,
I need some help in ICEM. I splitted a block, but with acticated "index control", so the edges are only splitted in this block, but not in the other adjacend blocks. Please see the picture: "Edge I" is a single edge but is divided into "edges II" and III in the right block. Now, "edge I" has 26 nodes, "edge II" has 12 nodes and "edge III" has 15 nodes, so they add to "edge I". My question is: How can I change the fraction of how nodes of "edge I" are divided into "edges II" and III? I want more nodes in "edge II" but keep the total number of nodes (of "edge I") constant. Is that possible? screen.jpg
__________________
The skeleton ran out of shampoo in the shower. |
|
August 22, 2013, 02:39 |
|
#3 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
Hey diamondx, great, that worked. Do you also know, where this information (fraction) is stored before I use the linked bunching?
__________________
The skeleton ran out of shampoo in the shower. |
|
February 16, 2016, 03:01 |
|
#4 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
I need to bump this old thread with a new, similar question.
Diamondx showed what to do with the linked bunching. Now in my current case I have a long edge in the middle (as in the post from diamondx) and smaller, divided edges on both sides. If I set the fractions on the left edges and in the middle correctly, everything is completetly messed up and distorted on the right edges. And vice versa. Is there any way I can get an equal distribution here? blocking.jpg This is a picture of the blocking (black) and the edges (red). Right side is fixed here, left side is garbage. If I fix the left side, then the right side is garbage.
__________________
The skeleton ran out of shampoo in the shower. |
|
|
|
LinkBacks (?)
LinkBack to this Thread: https://www.cfd-online.com/Forums/ansys-meshing/122525-edges-change-fractions.html
|
||||
Posted By | For | Type | Date | |
Cfd Online Discussion Forums - Ansys Meshing & Geometry Rss Feed | This thread | Refback | August 22, 2013 06:08 |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[ICEM] mesh is not aligned with edges | OliverL | ANSYS Meshing & Geometry | 0 | November 7, 2011 07:59 |
Edges in Gambit | Naghman Khan | FLUENT | 3 | October 3, 2007 06:36 |
Simple Meshed Edges Problem | Rich | Main CFD Forum | 1 | February 9, 2005 01:38 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |