|
[Sponsors] |
[Workbench] Creation of Cell Zones for processing in FLUENT |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Kai Ling
Join Date: Sep 2013
Posts: 8
Rep Power: 11 ![]() |
Hi,
I am building a simulation of a 3d box falling into a tank of water. I am trying to create cell zones for this project, however, after creating named selections for the box, the tank, inlet and outlet etc, only the tank appears when I proceed to setup under Cell Zone Conditions. May I know why is this so? Is there a criteria for FLUENT to process the named selections to become Cell Zones? Also, I am not very sure what I should classify as cell zone: i.e. in the ANSYS tutorial, 2D box falling into water, they have "fluid" and "moving_fluid" as their Cell Zones. Can anyone enlighten me on what are those 2 cell zones? Do I have to create another cell zone for the moving box (solid)? I am unable to open the mesh file to check as it is an imported mesh. Thank you ![]() Last edited by kailingkk; October 5, 2013 at 06:32. |
|
![]() |
![]() |
![]() |
Tags |
cell zones, falling box, mesh 3d |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cell Zones Recognition Problem | Maralady | FLUENT | 0 | June 19, 2013 14:00 |
Multiple urf settings on different cell zones | ReeKo | Fluent UDF and Scheme Programming | 1 | March 13, 2012 08:20 |
Mixed cell zone remeshing in FLUENT 12 | ChesterP | FLUENT | 6 | November 1, 2011 06:53 |
[Other] how to extract cell zones by cgnsToFoam | Ohbuchi | OpenFOAM Meshing & Mesh Conversion | 0 | July 22, 2010 04:19 |
Inputs for porous zones in FLUENT | Roel van Os | Main CFD Forum | 1 | September 1, 1998 12:41 |