[TurboGrid] Meshing a non flat tip blade

Luza Belmont · April 5, 2015, 00:32

Does anyone know how to mesh with turbogrid a non flat tip blade?, I mean a squealer tip blade? I tried to mesh it but when I give the clearance and run the mesh the tip looks like open and no tip geometry is showed.How do I must set up turbo grid to leave the tip geometry just as it is?

thanks for the information.

chocolater · September 4, 2017, 03:56

Hi Luza
Have you find any souloutin? I have the same problem for a blade with squler tip.

Far · September 6, 2017, 04:31

Quote:

Originally Posted by chocolater

Hi Luza
Have you find any souloutin? I have the same problem for a blade with squler tip.

This cannot not be in Turbogrid. Use ICEM CFD

Your geometry looks like this

alex-bishop · November 25, 2017, 09:59

hello.do you know how to mesh the non-flat tip blade in turbine by icem? can you teach me about that?

April 5, 2015, 00:32	Meshing a non flat tip blade	#1
Luza Belmont New Member Join Date: Dec 2014 Posts: 4 Rep Power: 12	Does anyone know how to mesh with turbogrid a non flat tip blade?, I mean a squealer tip blade? I tried to mesh it but when I give the clearance and run the mesh the tip looks like open and no tip geometry is showed.How do I must set up turbo grid to leave the tip geometry just as it is? thanks for the information.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] 3D meshing of a tortuous blade	Persil	ANSYS Meshing & Geometry	13	January 15, 2014 05:58
[ICEM] High Stagger Rotor Blade Meshing	eromon84	ANSYS Meshing & Geometry	12	August 14, 2013 07:40
[ICEM] Meshing a blade inside air volume	LittleBart	ANSYS Meshing & Geometry	19	October 10, 2012 10:20
[ANSYS Meshing] Meshing for flat plate immersed solid	hamed.majeed	ANSYS Meshing & Geometry	0	July 10, 2012 14:32
Meshing pitched blade turbine	Racheal	FLUENT	0	July 12, 2005 14:25

September 4, 2017, 03:56		#2
chocolater New Member i man Join Date: Feb 2013 Posts: 10 Rep Power: 14	Hi Luza Have you find any souloutin? I have the same problem for a blade with squler tip.

November 25, 2017, 09:59		#4
alex-bishop New Member Alex Join Date: Oct 2016 Posts: 16 Rep Power: 11	hello.do you know how to mesh the non-flat tip blade in turbine by icem? can you teach me about that?