[ICEM] Problems importing ICEM Mesh in CFD (visible cell region) -- CFD Online Discussion Forums

July 15, 2015, 04:36

Problems importing ICEM Mesh in CFD (visible cell region)

pizzaspinate

Member

Join Date: Dec 2012

Posts: 81

Rep Power: 13

Hey there,
I have meshed my geometry in ICEM and loaded it into CFD. However, I get funny cells (as shown in the picture). Does anyone know what causes this? I have run check Mesh in ICEM and it said everything is fine.

Thank you very much in advance for your help

Attached Images

ANSYS_error.jpg (24.9 KB, 3 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
ICEM CFD 5.0 - 2D to 3D Mesh Extrude	James Date	CFX	7	October 22, 2013 03:46
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
importing mesh from ICEM CFD into CFX 5	Jay	CFX	2	November 12, 2002 13:46

All times are GMT -4. The time now is 21:38.