|April 6, 2016, 15:51||
Inflation on a specific region created by projection tool
Pedro Henrique Di Giovanni Santos
Join Date: Apr 2016
Posts: 5Rep Power: 3
I have this domain to mesher on ANSYS CFX, the domain have 4 body and represent ľ of a symmetric geometry.
I need to created inflation layers in some regions like the figure bellow.
In Design Modeler, I use the Projection Tool to device one Face in many like the photo.
The previous results (Figura 2) are obtained with just one Body, but I need to create a similar result with a domains of 4 body, like the first imagem
When I go to Mesher and trayng to build the inflation layers on the especif regions I canít have the espected result.
Some one can help me?
Sorry by my English.
|April 7, 2016, 14:58||
I don't think this is actually possible in ANSYS Meshing. Might be with some further slicing into the big part and then "forming new part" in DesignModeler, but you might not be able to get the inflation layers to go around corners in a multibody part.
If you're in need of some free quality CFD video tutorials - check out SiriusCFD @ YouTube
|Thread||Thread Starter||Forum||Replies||Last Post|
|Simulation of a single bubble with a VOF-method||Suzzn||CFX||18||October 2, 2009 04:18|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|WeightedAverage for a specific cellZone region||guido_adriaensen||OpenFOAM Post-Processing||6||August 21, 2009 09:19|
|Two-Phase Buoyant Flow Issue||Miguel Baritto||CFX||4||August 31, 2006 12:02|
|Refining Mesh at Specific Region||Harmeet||CFX||1||October 17, 2004 18:44|