[BladeModeler] parametrization in BladeGen and DesignModel

mbrg · October 18, 2016, 11:40

Hi all,
I made a radial turbine design using BladeGen and I want to parametrized the meridional channel and the rotor angle. To do so I loaded the geometry into DesignModeler but I don't know why I am not able to find the control points that I use in BladeGen (4 points connected by a spline for Shroud and Hub Contour line) so I can not modify the geometry from the design modeler. I am able to parametrized the angle but not the meridional channel, any idea ?

My goal is to have a parameter set that can be automatically changed.

Any tips would be appreciated

rusty0632 · April 2, 2018, 07:00

Did you find a way to do this???

Rogers · April 15, 2018, 06:50

Hello,I want to know how do you parametrize the angle,thanks.

October 18, 2016, 11:40	parametrization in BladeGen and DesignModel	#1
mbrg New Member Join Date: Oct 2016 Posts: 1 Rep Power: 0	Hi all, I made a radial turbine design using BladeGen and I want to parametrized the meridional channel and the rotor angle. To do so I loaded the geometry into DesignModeler but I don't know why I am not able to find the control points that I use in BladeGen (4 points connected by a spline for Shroud and Hub Contour line) so I can not modify the geometry from the design modeler. I am able to parametrized the angle but not the meridional channel, any idea ? My goal is to have a parameter set that can be automatically changed. Any tips would be appreciated Rogers likes this.

April 2, 2018, 07:00		#2
rusty0632 New Member Konstantinos Join Date: Jul 2016 Location: Athens Posts: 7 Rep Power: 9	Did you find a way to do this???

April 15, 2018, 06:50		#3
Rogers New Member Rogers_Deng Join Date: Mar 2018 Posts: 2 Rep Power: 0	Hello,I want to know how do you parametrize the angle,thanks.