|
[Sponsors] |
[DesignModeler] Enclosure for a Building Area |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 7, 2017, 14:34 |
Enclosure for a Building Area
|
#1 |
New Member
Francesco Matacchiera
Join Date: Mar 2017
Posts: 9
Rep Power: 9 |
Hi all,
I am using Fluent (I am a fresh user) to analyse the wind flow in an urban area, so I modeled the buildings geometry in a easy way. The problem is with the enclosure as it should have a lower coushion (-Y axis) coincident wth the building basis, but if I do that, the inizialization will not converge. Any idea or something to suggest me the right modeling? Thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[foam-extend.org] Error compiling OpenFOAM-1.6-ext | Canesin | OpenFOAM Installation | 137 | January 20, 2016 14:56 |
Non overlap area fractions | saisanthoshm88 | CFX | 11 | September 17, 2015 18:42 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Compilation error OF1.5-dev on Suse10.3 | darenyang | OpenFOAM Installation | 0 | April 29, 2009 04:55 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |