|
[Sponsors] |
[ANSYS Meshing] Infaltion layer boundary selection |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 5, 2017, 14:31 |
Infaltion layer boundary selection
|
#1 |
New Member
inigo
Join Date: Oct 2017
Posts: 3
Rep Power: 8 |
Hello everyone,
I am a student who is new to ANSYS and I have been encountering problems with the inflation layer in the meshing found in fluent. I have watched videos and read instructions on how to do boundary layers. However, I have found difficulty in following instructions since I cannot select a boundary layer shown in the attached picture. Every time click apply nothing happens and it deselects the edges that I selected. What seems to be the problem here? Thank you for any help |
|
December 6, 2017, 05:00 |
|
#2 |
Member
Baris PULAT
Join Date: Sep 2016
Location: Italy
Posts: 59
Rep Power: 9 |
Hey ogini,
For the inflation you have 2 sets of geometry selection. I guess you have an external flow application. So you should go and first select the Scope Geometry with your enclosure. Second you have the boundary geometry which you will select according to the surfaces or edges that you want the inflation. |
|
December 6, 2017, 18:53 |
|
#3 |
New Member
inigo
Join Date: Oct 2017
Posts: 3
Rep Power: 8 |
Hi bpulat,
Thanks for taking time to read my post and helping me out. Yes I did select a scope geometry which was the flow domain. My problem only occurs when I select the edge for my boundary geometry. Whenever I click apply, it does not select it no matter how many tries I do. I have been stuck to this problem since it does not makes sense to me as well. |
|
December 7, 2017, 03:15 |
|
#4 |
Member
Baris PULAT
Join Date: Sep 2016
Location: Italy
Posts: 59
Rep Power: 9 |
Hey again,
I didn't see on my phone yesterday but also in your screenshot you can see there is something wrong with the geometry and i also suggest you to watch https://www.youtube.com/watch?v=fJuWUrZ1L9o Baris |
|
December 7, 2017, 15:07 |
|
#5 |
New Member
inigo
Join Date: Oct 2017
Posts: 3
Rep Power: 8 |
Hi again,
Thanks for helping me out. Can you point to me what you think is wrong with my geometry? I am new to ANSYS and I very much appreciate your help in this. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 04:39 |
A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 21:39 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |