|
[Sponsors] |
February 13, 2018, 07:34 |
Mesh of a splitted bodypart
|
#1 |
New Member
Hanna Wund
Join Date: Feb 2018
Posts: 1
Rep Power: 0 |
Hello,
I do have a task/mesh with several layers of different properities, I already created that ones and it worked. But sometimes there are two layers which have the same properties due to physical reasons there mesh should be in the same part of the part tree, also they have no common surface in the model. In my case it is the very top and the very bottem part of the object. Is that possible and how it that possible? Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 05:03 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |