|
[Sponsors] |
[ANSYS Meshing] Trailing Edge gets distorted in meshing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
February 4, 2019, 05:12 |
Trailing Edge gets distorted in meshing
|
#1 |
New Member
Samarth Kakkar
Join Date: Feb 2019
Posts: 1
Rep Power: 0 |
I am performing 2d analysis of FX-63137 airfoil on ANSYS fluent using Structured mesh and during meshing, the trailing edge gets distorted leading to very high aspect ratio elements as shown in the attached figure.
Kindly provide guidance for proceeding further. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trailing edge sensitivity anlaysis | JanH | SU2 | 2 | November 23, 2018 13:53 |
[ICEM] Prism layers distorted near trailing edge of blade-Unstructured Mesh | Rohith Giridhar | ANSYS Meshing & Geometry | 3 | June 29, 2015 17:52 |
Leading edge and trailing edge of an airfoil rotor blade | Jun_Milan | CFX | 0 | July 10, 2014 23:07 |
ICEM aircraft mesh trailing edge difficulty | MontyR | ANSYS Meshing & Geometry | 4 | July 23, 2011 21:46 |
trailing edge problem | Kuo Wei-Jen | Main CFD Forum | 2 | April 14, 1999 10:09 |