 |
 |
 |
|
|
|
[Sponsors] | ||||
March 12, 2019, 12:01
|
split block in icem
|
#1 |
|
New Member
Shay
Join Date: Oct 2017
Posts: 4
Rep Power: 8  |
Hello, I want to split only one block without the other parallel blocks being split.
The first image shows the current network. In the second picture, the black line shows the split of two blocks only by the bold black line. In the third picture, the green line that separates the other parallel blocks from which I want to avoid. Thank you |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Extrude 2D block for 2D simulation in ICEM | sunilpatil | ANSYS Meshing & Geometry | 4 | March 4, 2018 22:19 |
| [ICEM] Split blocks in ICEM | AdelMahgoub | ANSYS Meshing & Geometry | 4 | February 26, 2018 03:56 |
| [ICEM] Bottom-Up Block in ICEM | cfd seeker | ANSYS Meshing & Geometry | 1 | July 7, 2013 04:33 |
| foamLog not solving for Ux, Uy, Uz | aerospain | OpenFOAM Post-Processing | 5 | April 18, 2012 10:01 |
| how to combine multiple block files in ICEM? | kpv | CFX | 3 | December 13, 2007 08:12 |
Linear Mode
