|
[Sponsors] |
February 23, 2022, 10:58 |
boundary in spaceclaim
|
#1 |
Member
imane
Join Date: Aug 2018
Posts: 62
Rep Power: 7 |
hello!
I used SpaceClaim to split my geometry (a 3d tube) into 4 parts, after creating the mesh I named the faces as inlet outlets and walls (each one will contain 4 faces). when I import the mesh in fluent I got 4 inlets 4 outlets and 4 walls. I usually used designmodeler and by doing the same process I get only just one inlet, one out, and 1wall. Could anyone help me in resolving that problem? regards. Last edited by zahrae; February 24, 2022 at 09:22. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Windturbine simulation in SU2 | k.vimalakanthan | SU2 | 15 | October 12, 2023 05:53 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 08:16 |