|
[Sponsors] |
August 25, 2023, 02:19 |
error by inflation
|
#1 |
Member
Meysam
Join Date: Dec 2019
Posts: 81
Rep Power: 6 |
Hi everybody,
I am meshing a heater with many components such as a fan, heat exchanger, circuit board and so on. I usually mesh the stator and rotor separately. By meshing the stator domain when I want to set the inflation, I get the errors below:Inflation created stairstep mesh at some location & element volume exceeds the warning limit. a small element volume was encountered. Could you please guide me? regards, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Sweep methods with inflation | dokeun | ANSYS Meshing & Geometry | 0 | February 16, 2021 01:12 |
ANSYS Fluent Meshing: Incomplete Inflation Layers | sbro | FLUENT | 1 | October 26, 2020 15:04 |
[ANSYS Meshing] 3D Inflation mesh on an airfoil | kennyboy | ANSYS Meshing & Geometry | 1 | April 26, 2017 03:12 |
[ANSYS Meshing] Inflation Layers Being Finicky | Markua | ANSYS Meshing & Geometry | 12 | April 28, 2015 07:11 |
Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 12:11 |