|November 4, 2009, 22:33||
confused on CFX error message
Join Date: Nov 2009
Posts: 125Rep Power: 9
I defined a region in CFX-mesh called 'wall', and these areas defining the region 'wall' will have inflation applied.
an error from CFX-mesh is below:
refers to 12 primitive regions that do not appear in the geometry.
These regions are
In the end, volume mesh is generated BUT with the inflation ignored or not produced.
Why does this error occurs please?
Has it something to do with my imported CAD please?
I can select the areas which defines the location 'wall' in CFX-mesh.
I can still import this mesh into CFX-pre but the named 'wall' doesn't exists, and other region names don't appear for selection either.
i'm using ANSYS WB v11, CFX-Mesh v11.0, on a Win Vista 64-bit machine.
Thank you for your kind attention and i look forward to hear of any suggestions/comments.
|November 5, 2009, 06:45||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 13,074Rep Power: 101
You have to reselect the wall regions for the inflation to apply to.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pros and Cons for CFX, CFdesign, COMSOL||Val||Main CFD Forum||3||June 10, 2011 02:20|
|Importing solutions in CFX.||Alphonso||CFX||1||August 1, 2008 14:01|
|PhD using CFX||Rui||CFX||9||May 28, 2007 05:59|
|CFX 4.4 installation problem||Pandu Sattvika||CFX||1||December 1, 2001 05:07|