 |
 |
 |
|
|
|
[Sponsors] | ||||
September 23, 2010, 06:33
|
how hexahedral mesh is done
|
#1 |
|
New Member
harry
Join Date: Sep 2010
Posts: 4
Rep Power: 15  |
hello,
i am very new to this field. i am working on centrifugal pump. i was told to to do hexahedral meshing of the pump. since it's casing, water passage and impellor are not simple geometry(i.e. with continuing changing cross section). wat can i do abt it. |
|
|
|
|
| Tags |
| gambit 2.3 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| Hexahedral Mesh Generation software | makotohonda | Main CFD Forum | 1 | July 14, 2010 00:04 |
| [Other] Hexahedral mesh generation | makotohonda | OpenFOAM Meshing & Mesh Conversion | 0 | July 12, 2010 22:24 |
| Tetrahedral and hexahedral mesh based on FVM | kuang | Main CFD Forum | 0 | July 20, 2008 04:52 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Threaded Mode
