|
[Sponsors] |
September 16, 2011, 13:01 |
Loading previously saved mesh in ICEM CFD
|
#1 |
New Member
Join Date: May 2011
Posts: 23
Rep Power: 15 |
I have a 3D mesh in icem cfd with about 14million volume elements. I created the mesh, saved it, and now am trying to open the mesh up again in icem to further inspect it.
It has been trying to open for 4 hours and I keep getting messages: ----------- 38 edges found open edge near 1459368 1459369 triangle aspect = 0.320336 adding tri face at 1459368 1459369 2540613 36 edges found open edge near 1459369 2540613 disconnecting tri face at 1459369 2540613 1459368 ------------ What is the problem? Any suggestions appreciated. |
|
September 20, 2011, 13:46 |
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
It appears that only a partial mesh was saved and now it is trying to fill in the holes one element at a time...
You would probably appreciate this if there were just a few elements lost, but since it seems like perhaps many many (perhaps all the surface mesh) elements are lost, it will probably be much faster to abort and generate the mesh again. I am not sure how you got to this stage in the first place...
__________________
----------------------------------------- Please help guide development at ANSYS by filling in these surveys Public ANSYS ICEM CFD Users Survey This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)... CFD Online Users Survey |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Import Mesh from ICEM CFD to CFX | Andre Almeida | CFX | 16 | April 19, 2016 04:42 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
ICEM CFD 5.0 - 2D to 3D Mesh Extrude | James Date | CFX | 7 | October 22, 2013 04:46 |
[ICEM] Problem with volume mesh in ICEM CFD | kolapoasafa | ANSYS Meshing & Geometry | 2 | September 16, 2011 04:54 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |