 |
 |
 |
|
|
|
[Sponsors] | ||||
June 26, 2014, 17:22
|
[Workbench] simple mesh question
|
#1 |
|
New Member
Leon
Join Date: Jun 2014
Posts: 1
Rep Power: 0  |
Hi all!
(Sorry for my English) Lets say I have a 2D square 10x10 [mm] (without hole). I want to refine in the center of this square, within an area of 2[mm] diameter circle (not only near the edges). How should I do it? Thanks for the help! |
|
|
|
|
|
July 16, 2014, 14:50
|
|
#2 |
|
New Member
Liam
Join Date: Sep 2013
Location: Calgary, Alberta
Posts: 19
Rep Power: 14  |
Create a coordinate at the centre of your square and insert a "sphere of influence" in the middle.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 12:14 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| Question on InterFoam moving mesh capabilities | ziv | OpenFOAM Running, Solving & CFD | 0 | April 23, 2008 10:11 |
Linear Mode
