[tjt]

Noob Ansys user here....

In ansys APDL, the /clear command brings up a pop-up box saying 'SHOULD THE /CLE COMMAND BE EXECUTED?' with Yes + NO buttons to click.

I have written a script to read in a database, perform some operations, clear the database load in a second database, perform the operations again and so on. The script uses the /clear command.

My question is how to suppress the Yes / No verify box so I can let this run overnight without any human interaction.

I have researched this a bit and found the /NERR command isn't much use as the message isnt an error or a warning and also not had much luck with /UIS either

Do you lovely people have any suggestions or experience with this? Any suggestions would be very welcome :-)