Entries for December 2012

I agree with "Far", but don't recommend the Hexadominant method for CFD.

The Hexadominant method starts by paving quads at the walls and then marches inward with isotropic hexas which can crash somewhat badly in the middle. This is good for FEA structural analysis where most of the interesting stuff happens near the surface and uniform elements are sufficient to capture it all, but it is not good for CFD.

However, if you tried Multizone (or sweep) with...

Actually CFD Post does support FLUENT transient files, but you should open a dat file that uses the FLUENT transient naming conventions, that is, filename-XXXXX.dat, where XXXXX is the timestep number. Your cas file should be named filename.cas (without the timestep number). If you have other cas files with the timestep number, try moving them to another folder.

I use it here a lot and it works fine.

Cheers.

By BRUNOC

you can only merge meshes if one side is all tetra... It needs the flexibility of the tetra mesh make it work. Prisms are too restrictive. We are working on ways to improve this situation.

Prism quality looks worse than it is... No worries there either.

As for the poor tetras, run the smoother with the prisms and hexas frozen... see what it can do. It should fix most tetras. The tetras it can't fix are those that are stuck between close layers of prisms... ...