|
[Sponsors] |
August 3, 2005, 17:31 |
problems replacing old boundaries
|
#1 |
Guest
Posts: n/a
|
I have been using simple boundaries on some complex models and allowing them to converge. I then put the correct boundaries on and let the model converge but the results are the same as with the simple boundaries. I am writing a new problem file after applying these new boundaries. Anything else that should be done?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] ParaView Postprocessing problems with cyclic boundaries | christian | ParaView | 10 | June 26, 2009 05:49 |
Replacing Zones | Steve | FLUENT | 0 | December 4, 2007 00:13 |
[blockMesh] Problems with cyclic boundaries in blockMesh | marhamat | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2007 10:06 |
Replacing components in a scalarField | grtabor | OpenFOAM Running, Solving & CFD | 1 | February 5, 2007 12:24 |
Problems with different boundaries | Sven | Siemens | 0 | November 24, 2003 11:00 |