CFD Online Logo CFD Online URL
Home > Forums > FLUENT

Replacing Zones

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   December 4, 2007, 01:13
Default Replacing Zones
Posts: n/a
Dear all,

I have a mesh which is divided into several zones. I have a converged solution and now I wish to replace on of the zones with a finer mesh (identical geometry). I would like the current velocity field to be interpolated to the new mesh. Firstly, am I correct in thinking this is possible?

I have tried this and encountered a problem with the geometry scale. The original mesh was created in millimeters and then converted to meters in FLUENT. Hence when the mesh is replaced it is 1000 time too large. I seem to be able to work around this by scaling the mesh back to mm before replacing the zone. Is this the only workaround?

However, when I try the zone replace, FLUENT warns of a segmentation fault and crashes. I have tried a number of things, such as splitting the interface boundaries, without success.

Any suggestions will be gratefully received!
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
merge zones Domi FLUENT 1 February 21, 2016 14:59
how to extract cell zones by cgnsToFoam Ohbuchi OpenFOAM Meshing & Mesh Conversion 0 July 22, 2010 04:19
Skipping Zones 1337Hal FLUENT 0 April 6, 2009 21:19
about seperating zones Bono FLUENT 1 October 8, 2005 06:08
Patch-Different values to different zones Pradeep FLUENT 0 April 26, 2005 08:50

All times are GMT -4. The time now is 00:25.