|
[Sponsors] |
May 30, 2007, 10:04 |
cyclic boundaries
|
#1 |
Guest
Posts: n/a
|
hi i've been trying to set the CYCLIC BOUNDARIES for the 30*-piece of a burner but the only thing i've been receiving is the message that CYCLIC BOUNDARIES ARE NOT MATCHED; i'd be grateful for any hints thx in advance
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cyclic boundaries | Zealouk | Siemens | 0 | September 17, 2008 11:28 |
error in cyclic boundaries match | Steve | Siemens | 2 | March 4, 2008 04:32 |
[OpenFOAM] View cyclic boundaries using MRFSimpleFoam | gabriel | ParaView | 0 | July 27, 2007 08:42 |
[Gmsh] Cyclic boundaries | sampaio | OpenFOAM Meshing & Mesh Conversion | 1 | February 7, 2006 13:26 |
CYCLIC BOUNDARIES MATCHING | robert | Siemens | 3 | September 7, 2000 01:08 |