 |
 |
 |
|
|
|
[Sponsors] | ||||
April 15, 2019, 08:19
|
FAN 3D geometry and meshing for ANSYS FLUENT
|
#1 |
|
New Member
Join Date: Feb 2017
Posts: 1
Rep Power: 0  |
Good morning,
In the past, for this kind of simulation I used Gambit without problems. - Geometry:1-> Volume, wing volume and propeller disk surface as FAN definition. 2-> Subtract Volume and wing volume to create fluid volume domain. 3 -> Split the fluid volume domain with propeller disk surface. That's all. 4 -> Meshing. 5 -> Fluent and boundary condition definition as FAN Could you be so kind to explain how to proceed with ANSYS workbench XX.Y Thank you in advance |
|
|
|
|
| Tags |
| ansys 14, desingmodeler, fan bc, gambit 2.4.6, mesh 3d |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cannot import Geometry into Fluent Meshing 2019 R1 | edward.pocock | FLUENT | 2 | January 15, 2024 04:33 |
| [ANSYS Meshing] polyhedral mesh which is generated directly in Workbench Poly Meshing for Fluent | teguhtf | ANSYS Meshing & Geometry | 0 | January 24, 2019 22:04 |
| [ANSYS Meshing] CATIA Geometry Generation and Meshing | danielsullivan | ANSYS Meshing & Geometry | 0 | April 3, 2017 21:11 |
| [DesignModeler] Importing Solid Edge ST4 Geometry into Ansys Fluent 13.0 for meshing | The Mighty Rearranger | ANSYS Meshing & Geometry | 0 | November 27, 2012 12:44 |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
Threaded Mode
