CFX Solver error

sunilpatil · July 31, 2012, 15:23

Hello sir,
i am getting the following error when i changed the mesh size (spacing 0.05 to 0.005 and ratio 2 to 1.2)

ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| *** Run-time memory allocation error *** |
| Not enough free memory is currently available on the system. |
| Could not allocate requested memory - exiting!
how to fix this problem

ghorrocks · July 31, 2012, 19:10

The problem is pretty obvious - you have run out of memory.

Options include:
* Get more memory
* Run parallel
* Turn physics off to make the model smaller
* Run single precision (if you are running double precision)

July 31, 2012, 15:23	CFX Solver error	#1
sunilpatil Senior Member sunil Join Date: Jul 2012 Location: Bangalore Posts: 181 Rep Power: 14	Hello sir, i am getting the following error when i changed the mesh size (spacing 0.05 to 0.005 and ratio 2 to 1.2) ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| * Run-time memory allocation error * \| \| Not enough free memory is currently available on the system. \| \| Could not allocate requested memory - exiting! how to fix this problem

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem running perturbUCyl	sen.1986	OpenFOAM	17	June 4, 2019 05:56
Compile problem	ivanyao	OpenFOAM Running, Solving & CFD	1	October 12, 2012 09:31
CGNS lib and Fortran compiler	manaliac	Main CFD Forum	2	November 29, 2010 06:25
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..."	sega	OpenFOAM Community Contributions	12	February 17, 2010 09:30
Compiling problems with hello worldC	fw407	OpenFOAM Installation	21	January 6, 2008 17:38

July 31, 2012, 19:10		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,934 Rep Power: 145	The problem is pretty obvious - you have run out of memory. Options include: * Get more memory * Run parallel * Turn physics off to make the model smaller * Run single precision (if you are running double precision)