|
[Sponsors] |
April 28, 2013, 13:42 |
Question about Ansys Workbench
|
#1 |
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Hi
I'm looking for a Ansys CFX Workbench tutorial. I searched for it online but found nothing. Where could I find one? I'd like to know how to setup a loop so that Workbench can change the inlet velocity of my simulation automatically. Then run the simulation automatically. Then export the pressure of one point automatically to a formula (like editor or excel sheet). In this way, I won't need to always change the inlet velocity and record the simulation results (the pressure at a point) manually. May I ask how to set up Workbench to achieve that? Thank you very much!
__________________
Best regards, Meimei |
|
April 28, 2013, 18:53 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
There are lots of tutorials for Workbench on the ANSYS Customer site, including using parameters to drive simulations like you are looking for.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit vs. Ansys workbench mesh generating | sanlee39 | Main CFD Forum | 2 | April 8, 2013 06:09 |
ANSYS Workbench 11 backup problem, | mechanicaldesign | ANSYS | 0 | June 21, 2011 01:48 |
mesh in ansys workbench | swe704 | ANSYS Meshing & Geometry | 1 | May 15, 2011 12:20 |
Ansys workbench 12 and 12.1 | ACER | CFX | 0 | April 29, 2011 21:43 |
Ansys workbench problem | Jonny6001 | ANSYS | 2 | September 30, 2010 12:59 |