[Anna Tian]

I run CFX simulation by workbench. After I start to run the simulation, the simulation stuck at the message:

‘The MeTiS partitioning method allocates additional memory. Total memory usage will therefore exceed the values shown above.’

Then the simulation doesn’t proceed anymore.

I’m quite sure that I shall have enough memory (128 GB) available for that simulation (16 millions structured grids from ICEM, steady state SST).

The bad thing is: it doesn't give any error information. So that I have no clue what causes the problem and how to solve it.

I’m wondering what’s the reason of it? And how to solve this problem? Any hint?