 |
 |
 |
|
|
|
[Sponsors] | ||||
May 15, 2016, 16:33
|
ICEM OR TURBO-Grid
|
#1 |
|
New Member
AHMED LAOUARI
Join Date: May 2016
Posts: 2
Rep Power: 0  |
hi,
I would like to meshing runner blades, can you suggest the best software meshing between Icem and turbo-grid thanks |
|
|
|
|
|
May 16, 2016, 01:36
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
The best software is the one you can use successfully to get the job done. So arrange a trial of both of them and give them a go at doing the task you need to do. Then you will find out for yourself which software is best for your task.
|
|
|
|
|
|
|
May 17, 2016, 02:40
|
|
#3 |
|
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
TurboGrid has a nicer GUI. In case you don't have any meshing experience, you will probably achieve results more quickly with TurboGrid.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [TurboGrid] Exporting mesh from Turbo grid in .msh format | Jack001 | ANSYS Meshing & Geometry | 0 | January 19, 2016 14:25 |
| [Commercial meshers] turbo grid | amiri | OpenFOAM Meshing & Mesh Conversion | 1 | April 20, 2015 07:41 |
| [TGrid] Generating Volume Mesh in ICEM and Generating Prism in T grid | hasanifte | ANSYS Meshing & Geometry | 0 | March 30, 2015 15:48 |
| [ICEM] Structured grid without blocking in ICEM | BahaZero | ANSYS Meshing & Geometry | 19 | March 5, 2013 11:36 |
| a question about generating grid used by icem | sweet0575 | CFX | 1 | April 13, 2009 23:31 |
Linear Mode
