 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2018, 10:51
|
Fitting casing treatment on rotor
|
#1 |
|
Senior Member
Join Date: Aug 2012
Posts: 268
Rep Power: 14  |
Hi,
I am using bladegen to design a rotor blade row where a type of casing treatment will be attached to the rotor (image 1). I used straight lines to define the space required to attach casing treatment later. However, when I import the geometry to turbogrid or ICEM, the straight lines become curved (image 2), so the casing treatment does not fit the space perfectly. Any idea what I should do to keep their shapes as shown in bladegen? Thanks! |
|
|
|
|
|
May 11, 2018, 07:21
|
|
#2 | |
|
Senior Member
Join Date: Aug 2012
Posts: 268
Rep Power: 14 |
I forgot to upload a screenshot from CFX-Pre. Due to the change of shroud curve a gap arises between the casing treatment and the rotor.
Does it affect the result? Quote:
|
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The simulation of a centrifugal compressor with holed casing treatment | gongmq | CFX | 4 | July 16, 2018 05:15 |
| Interfaces between blade channel and casing treatment | SNeCu | CFX | 3 | September 20, 2017 22:36 |
| Add casing treatment in NUMECA | SNeCu | Fidelity CFD | 9 | July 24, 2017 23:15 |
| Rotor Torque Prediction | jason | OpenFOAM Running, Solving & CFD | 7 | August 16, 2016 09:34 |
| CFD analysis on wind turbine rotor | Ken (Wind Turbine CFD Super Rookie) | Main CFD Forum | 45 | February 9, 2016 14:07 |
Linear Mode
