|
[Sponsors] |
May 25, 2005, 12:23 |
How to creat geometry like this?
|
#1 |
Guest
Posts: n/a
|
A pipe with a plane at the middle of the pipe, a hole was in the plane, so how to creat this pipe? Thanks.
|
|
May 25, 2005, 18:30 |
Re: How to creat geometry like this?
|
#2 |
Guest
Posts: n/a
|
Hi,
Sounds like simple solid modelling to me. ANSYS Workbench should be able to do it easily. Do some tutorials and it should be easy. Regards, Glenn Horrocks |
|
May 26, 2005, 20:04 |
Re: How to creat geometry like this?
|
#3 |
Guest
Posts: n/a
|
Thanks, could you please try one since it is so simple for you? And please let me know the major procedures. Thanks.
|
|
June 7, 2005, 06:10 |
Re: How to creat geometry like this?
|
#4 |
Guest
Posts: n/a
|
Ok, dayanjing, you want to do something but you don't even want to try first. If you are using DesignModeler, i'd like to tell you how to do it, it is simple, as Glenn said.
Regards, Forrest |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |
How to creat the geometry of a tapered pipe? | Lee | Siemens | 2 | September 1, 2003 10:36 |