|
[Sponsors] |
June 5, 2006, 22:11 |
how to change the size of BC's arrow?
|
#1 |
Guest
Posts: n/a
|
as the title,so appreciate someone can tell me:"how to change the size of BC's arrow in CFX10?"
thanks a lot!!! |
|
June 6, 2006, 05:25 |
Re: how to change the size of BC's arrow?
|
#2 |
Guest
Posts: n/a
|
In Pre? Not possible, so far I know
|
|
June 6, 2006, 09:25 |
Re: how to change the size of BC's arrow?
|
#3 |
Guest
Posts: n/a
|
i think there must some sysytem configurations to let them go!---------i will cencern on this!!!
|
|
June 6, 2006, 09:56 |
Re: how to change the size of BC's arrow?
|
#4 |
Guest
Posts: n/a
|
You can't change the size, but you can turn them off. Click on the "Label Marker and Visibility" icon in the control bar above the viewer to access the controls.
Regards, Robin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |
OpenFOAM 13 AMD quadcore parallel results | msrinath80 | OpenFOAM Running, Solving & CFD | 1 | November 10, 2007 23:23 |
Stack frame size, Origin 2000, fortran, a question. | Sergei Chernyshenko | Main CFD Forum | 4 | February 22, 1999 14:24 |