 |
 |
 |
|
|
|
[Sponsors] | ||||
ICEM How to display surface elem. orientation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 8, 2006, 03:01
|
ICEM How to display surface elem. orientation
|
#1 |
|
Guest
Posts: n/a
|
Hallo all, I have simple and very unconvinietn problem with meshing a surfaces in ICEM CFD - I dont know how to display element coordination system for every surface element in model. Can anyone help?
Luk |
|
|
||
|
September 8, 2006, 07:35
|
Re: ICEM How to display surface elem. orientation
|
#2 |
|
Guest
Posts: n/a
|
You can display surface element normal by right-clicking on Shells from the Mesh branch and selecting Face Normals.
|
|
|
|
||
|
September 8, 2006, 09:37
|
Re: ICEM How to display surface elem. orientation
|
#3 |
|
Guest
Posts: n/a
|
Hallo, Yes but there are only normal vectors. I meant what to do to have full coordinate system like in Ansys PlotControl->Symbol->Esys (Element Coordinate System).
Luk |
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Snappy: cell normal orientation on open surface | Nolwenn | OpenFOAM Meshing & Mesh Conversion | 15 | December 29, 2021 01:26 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] export tetra surface mesh in ICEM | sivarama1 | ANSYS Meshing & Geometry | 5 | May 24, 2009 15:39 |
| free surface display | carno | Siemens | 4 | October 7, 2005 01:03 |
| icem surface problems | joe | Main CFD Forum | 0 | February 11, 2004 17:20 |
Linear Mode
