|
[Sponsors] |
January 29, 2007, 11:04 |
ICEM Postprocessing
|
#1 |
Guest
Posts: n/a
|
Is it possible to make screenshots with a custom resolution? By default, ICEM saves screenshots using the current display resolution. I would like to make pictures with higher resolution.
|
|
January 30, 2007, 06:43 |
Re: ICEM Postprocessing
|
#2 |
Guest
Posts: n/a
|
One workaround is to save the plot as a postscript (ps) file. Then open the file in GSView from Ghostgum Software and use the Convert/png16m with dpi 600.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
surface flow lines in ICEM postprocessing | Dimitri | CFX | 0 | July 18, 2007 11:30 |
ICEM 10 mesh scale foe CFX | Korsh Mik | CFX | 2 | October 7, 2005 09:07 |