Home > Forums > Software User Forums > ANSYS > CFX

what is the concept of orient block?

Mark Forums Read

Reply

Search this Thread

April 6, 2007, 13:54	what is the concept of orient block?	#1
nina Guest Posts: n/a	Hi, I have general query in icem. When I am going to make a block by orient ( so that it can orient with geom, and I havent to make break the block). But there is no connectivity of one to one , when I am going thru this appproch. So, why this happens? Or should we directly go thru making a blcok and then break it? Thanks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Quest for seemingly simple Blocking (degenerate block)	la7low	ANSYS Meshing & Geometry	0	July 12, 2011 20:48
[Commercial meshers] Icem Mesh to Foam	jphandrigan	OpenFOAM Meshing & Mesh Conversion	4	March 9, 2010 03:58
blockMesh: block with 6 vertexes	dani	OpenFOAM	3	June 25, 2009 14:13
what is orient block in icem?	suresh	CFX	0	April 19, 2007 13:52
what is orient block in icem	suresh	CFX	0	April 13, 2007 11:33

All times are GMT -4. The time now is 07:40.