 |
 |
 |
|
|
|
[Sponsors] | ||||
parameters of the BladeGen initial pressure/suction dialog |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 16, 2021, 06:52
|
parameters of the BladeGen initial pressure/suction dialog
|
#1 |
|
New Member
Bassam Elsayed
Join Date: Sep 2021
Posts: 13
Rep Power: 6  |
i want to transform the cascade notation in blade geometry(fig.2) to use it in the BladeGen initial pressure/suction dialog (fig.1). as the dialog window does not have any notation for the 9 parameters.
Last edited by bassamelsayed; September 16, 2021 at 06:55. Reason: the attached photos did not appeared |
|
|
|
|
|
| Tags |
| bladegen |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 15:26 |
| Problem with chtMultiregionFoam radiation boundary condition | baran_foam | OpenFOAM Running, Solving & CFD | 10 | December 17, 2019 18:36 |
| Free surface issues with interDyMFoam for hydroturbine | oumnion | OpenFOAM Running, Solving & CFD | 0 | October 6, 2017 15:05 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |
Linear Mode
