 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2007, 16:27
|
Stirred Tank
|
#1 |
|
Guest
Posts: n/a
|
Hello! Im having some problems simulating the flow in a stirred tank at 450 RPM.The velocities and presure are too high up to 3000 m.s^-1and 4x10^8 Pa.
Thanks! |
|
|
||
|
May 7, 2007, 19:26
|
Re: Stirred Tank
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Sounds like it is diverging. It could be a physical problem (ie incorrect simulation setup) or a numerical problem (ie not converging). Have a look in the CFX documentation on obtaining convergence. Glenn Horrocks |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stirred tank, TKE, DES, RSM | J. Gimbun | FLUENT | 0 | February 21, 2006 06:57 |
| Stirred Tank Geometry in Ansys | gopalkasat | CFX | 6 | December 22, 2004 14:32 |
| Boundary conditions for stirred tank | Jingo | Main CFD Forum | 2 | October 20, 2003 14:21 |
| CFX 5.5.1 stirred tank and LES problem | Nishant | CFX | 2 | September 13, 2002 08:11 |
| Flow patterns in a stirred tank | Glenn Price | Main CFD Forum | 13 | March 20, 1999 11:16 |
Linear Mode
