|
[Sponsors] |
February 23, 2022, 21:03 |
CFX transient results
|
#1 |
New Member
Evelyn
Join Date: Mar 2021
Posts: 15
Rep Power: 5 |
I have a question about the results of the CFX transient calculations. I use the CFX module in Workbench to do my simulation, and I set up a time list of results I want to save in the "output control" tab of the CFX Pre. When I go to the Results TAB in Workbench, I can easily open the CFD Post and see all the time step results I have saved. However, if I import the .res and .out file to CFD-Post or Tecplot, I could only see the result of the end time.
|
|
February 24, 2022, 01:14 |
|
#2 |
New Member
Evelyn
Join Date: Mar 2021
Posts: 15
Rep Power: 5 |
I found the cause of the problem. The .res and .out files save only the data for the last time step, You need to make sure that the .res and .out files are in the same directory as the .trn files which save the results of other time lists. In this way, you can open the results of all the time lists
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time average results in Transient CFX Simulation | BalanceChen | CFX | 32 | September 30, 2021 13:59 |
Transient simulation gives worse results than steady state simulation | jgross | CFX | 12 | January 21, 2021 12:21 |
CFX transient with tracer errors | CFDHeisenberg | CFX | 2 | October 12, 2020 12:27 |
CFX FSI Fatal Error | unbanana | CFX | 0 | October 3, 2015 05:57 |
Error writing transient results in FSI | CFX | 1 | April 15, 2010 06:57 |