Adjust the parameter of the geometry

November 5, 2007, 10:09

Hi, everyone, in ICEM CFD, first I have made a cylinder, but later I want to adjust the height of the cylinder and add points to the base surfaces. Every time I have to redraw the geometry, and it is time-consuming. Whether is it possible that just adjusting the parameters of the original geometry? If it is, how?

Thanks a lot!

Susan

November 5, 2007, 17:07

Hi,

Parametric modelling is best done in Workbench.

Glenn Horrocks

November 9, 2007, 07:42

Thank you for your reply. I havn't installed the workbench. So it seems that the parameters of geometry can't be adjusted in ICEM.

November 5, 2007, 10:09	Adjust the parameter of the geometry	#1
Susan Guest Posts: n/a	Hi, everyone, in ICEM CFD, first I have made a cylinder, but later I want to adjust the height of the cylinder and add points to the base surfaces. Every time I have to redraw the geometry, and it is time-consuming. Whether is it possible that just adjusting the parameters of the original geometry? If it is, how? Thanks a lot! Susan

November 5, 2007, 17:07	Re: Adjust the parameter of the geometry	#2
Glenn Horrocks Guest Posts: n/a	Hi, Parametric modelling is best done in Workbench. Glenn Horrocks

November 9, 2007, 07:42	Re: Adjust the parameter of the geometry	#3
Susan Guest Posts: n/a	Thank you for your reply. I havn't installed the workbench. So it seems that the parameters of geometry can't be adjusted in ICEM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Force can not converge	colopolo	CFX	13	October 4, 2011 22:03
[Gmsh] Problem meshing an imported geometry	Alicia	OpenFOAM Meshing & Mesh Conversion	0	March 30, 2010 04:53
Simulation of Flow through Complex 3D Geometry	EmersonKB	CFX	5	July 2, 2009 08:17
vitual _ real	deneb	FLUENT	3	January 22, 2007 04:31