Blocking in ICEM

January 29, 2008, 15:57

Hi

What is the difference between deleting the block to tell ICEM that it is solid surface and its not suppose to mesh it, and creating part (create part with blocks) and then moving it VORFN. In either case we get a solid object so there is no difference right?

CFD newbie

January 30, 2008, 08:58

It's the same, yes. You can extract "deleted" blocks, by moving them from VORFN.

January 30, 2008, 12:46

Thank you Dr. Squad.

CFD newbie

January 31, 2008, 09:01

If you want mesh propagations to be the same either side of a deleted block without having to set it on each block separately; then move the block to be deleted into VORFN.

January 29, 2008, 15:57	Blocking in ICEM	#1
CFD newbie Guest Posts: n/a	Hi What is the difference between deleting the block to tell ICEM that it is solid surface and its not suppose to mesh it, and creating part (create part with blocks) and then moving it VORFN. In either case we get a solid object so there is no difference right? CFD newbie

January 30, 2008, 08:58	Re: Blocking in ICEM	#2
Dr. Flow Squad Guest Posts: n/a	It's the same, yes. You can extract "deleted" blocks, by moving them from VORFN.

January 30, 2008, 12:46	Re: Blocking in ICEM	#3
CFD newbie Guest Posts: n/a	Thank you Dr. Squad. CFD newbie

January 31, 2008, 09:01	Re: Blocking in ICEM	#4
James Date Guest Posts: n/a	If you want mesh propagations to be the same either side of a deleted block without having to set it on each block separately; then move the block to be deleted into VORFN.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Using Blocking with ICEM (infinity lines appear)	Touré	ANSYS Meshing & Geometry	6	August 5, 2012 17:07
No Blocking tab in Ansys ICEM CFD11.0	NewGuy	CFX	1	November 22, 2010 15:38
Ansys ICEM 12.0 Searching for tutorial information on complex 3d blocking	Raoul	ANSYS	1	October 18, 2010 06:08
ICEM blocking	Chris Wetton	CFX	6	March 9, 2008 05:18
ICEM Blocking 2D and Fluent error	Dr. Flow Squad	FLUENT	3	March 5, 2007 02:27