|
[Sponsors] |
July 16, 2008, 13:43 |
Icem Cfd To Cfx B.C. Problem
|
#1 |
Guest
Posts: n/a
|
Hi
I am learning the ICEM CFD, and I have a problem with the export function. I have made a mesh following the tutorials, and I want to import it to CFX. When I am going to give B.C. for ANSYS CFX SOLVER (in the ICEM CFD), there are no B.C. to choose and when I open it in cfx there is only the main domain with out any areas. So I Can't import B.C. to cfx.. Any Idea? Thank you |
|
July 16, 2008, 22:20 |
Re: Icem Cfd To Cfx B.C. Problem
|
#2 |
Guest
Posts: n/a
|
Did you really create your "Part" part (2D region) on ICEM CFD?
Look at this: http://www.4shared.com/file/52225485...com2RevOK.html |
|
July 17, 2008, 01:50 |
Re: Icem Cfd To Cfx B.C. Problem
|
#3 |
Guest
Posts: n/a
|
Hi,
If you are using ICEM CFD as part of workbench (ie CAD2MESH) then you should not need to export to CFX. Use the analysis output buttons on the main toolbar. To get boundary regions on the mesh assign the boundaries as different parts. The mesh associated with these parts will then come into CFX as different boundary regions. Glenn Horrocks |
|
July 17, 2008, 11:21 |
Re: Icem Cfd To Cfx B.C. Problem
|
#4 |
Guest
Posts: n/a
|
Î' again. Thanks for the help here. I found that the problem finally is not at the mesh exporting, but at the mesh generation.
My problem which I try to solve is like a cube with an inlet (a rectangular hall in the front side) and an outlet (a rectangular hall on the back side). The problem is that, while I have made parts, in the Pre-mesh it does not break the parts on the same surface. I tried to make a volume mesh, but then I loose the inflation that I have on the grid, |
|
July 17, 2008, 12:49 |
Re: Icem Cfd To Cfx B.C. Problem
|
#5 |
Guest
Posts: n/a
|
Hi
I found the error. I just had to split the the block at the specific points... thnks for the help |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Icem CFD Meshing Problem | eRzBeNgEl | ANSYS | 1 | January 20, 2011 07:55 |
[ICEM] Meshing problem from ICEM CFD to Fluent | cfdonlinederafa | ANSYS Meshing & Geometry | 2 | September 21, 2010 16:16 |
ICEM CFD 5.0 - CFX mesh problem | NeedHelp | CFX | 2 | January 4, 2005 13:45 |
Error message in ICEM CFD 5.0 - CFX | Haferbrei | CFX | 2 | November 2, 2004 07:44 |
Where do we go from here? CFD in 2001 | John C. Chien | Main CFD Forum | 36 | January 24, 2001 21:10 |