|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
King
Join Date: Mar 2009
Posts: 8
Rep Power: 18 ![]() |
I am currently working on a model where I have both water and air acting as fluid. The water flows through a microchannel with air trapped in the gaps preventing the water from flowing into the gaps. I need to find out the heat transfer between the water and the microchannel. I am using Volume of Fluid (VOF) method to model the fluid. When I tried to solve it says error solving multiphase flow. Can anyone tell me how to solve this multiphase flow?
Thank you |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,970
Rep Power: 145 ![]() ![]() ![]() ![]() |
Hi,
Have a look at the free surface flow over a bump tutorial. This will show you the basics of how to set up this type of model. Glenn Horrocks |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to check Heat Balance in heat transfer like mass balance for flow | mahendra | OpenFOAM Post-Processing | 15 | February 8, 2012 10:19 |
No results for solid domain | Gary Holland | CFX | 10 | March 13, 2009 03:30 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
axial flow around a cylinder -heat transfer model? | Ralf Schmidt | Main CFD Forum | 1 | March 21, 2006 08:54 |
Periodical Oscillating flow heat transfer | S.L.ZHOU | Main CFD Forum | 0 | September 20, 2000 22:22 |