|
[Sponsors] |
October 7, 2017, 13:13 |
Error different streams
|
#1 |
New Member
Hamed
Join Date: May 2017
Posts: 26
Rep Power: 9 |
Hi,
What are the possible causes of this error? "reading surface.dat data from file surface.dat JOB ABORT invoked by rank 0: ERROR: neighboring triangles are associated with different streams--this is not allowed." I prepared a geometry and implemented the following: 1-To fix the problems in diagnostic dock. 2-To create a new liner and check the alignment between head and piston. 3-Check the piston motion along the Z-axis. Thanks in advance |
|
October 9, 2017, 15:45 |
|
#2 |
Member
Tristan Burton
Join Date: Sep 2017
Posts: 92
Rep Power: 8 |
Hamed,
Can you share the text of your initialize.in file? Best regards, Tristan |
|
October 9, 2017, 17:34 |
|
#3 | |
New Member
Hamed
Join Date: May 2017
Posts: 26
Rep Power: 9 |
Quote:
I don't have accurate data and I initially imported it as an approximation. I don't think this error related to this issue. I also removed ports and valves,and filled the head using patch option, my case began to run. I used this test separately for ports, but this test didn't work with geometry without valves. therefore, i tried to improve head of my SCOTE engine and it was worked, but didn't work with valves. Is it important which software to use for meshing (stl file)? Thanks for your help Regards, Last edited by hamedc; October 14, 2017 at 17:38. |
||
October 11, 2017, 12:24 |
|
#4 |
Member
Tristan Burton
Join Date: Sep 2017
Posts: 92
Rep Power: 8 |
Hamed,
Why is Region 1 assigned to stream_id 1? Unless you're doing CHT including solids, everything is usually in stream_id 0. Best regards, Tristan |
|
October 11, 2017, 15:20 |
|
#5 |
New Member
Hamed
Join Date: May 2017
Posts: 26
Rep Power: 9 |
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM-Number of streams in pressure swirl atomizer | Zari | FLUENT | 1 | February 7, 2017 03:53 |
DPM input parameter ( no. of particle streams ) | omar.asurt | Fluent Multiphase | 1 | February 6, 2017 05:50 |
loop over all injection streams in order to get the particles specifications | alighaffari | Fluent UDF and Scheme Programming | 0 | August 28, 2012 01:42 |
loop over all injection streams | alighaffari | Main CFD Forum | 1 | August 27, 2012 16:00 |
data streams as boundary condition(s) ? | Jim87 | FLUENT | 0 | September 29, 2011 10:06 |